Greetings All,
I hope you can help me.
I need to apply PageLabel text to PDFs passed through assembler.
As long as the test is not rotated, I am able to set the margins as I desire to get the labels pinned to the lower left or lower right corners.
If I rotate the text 90 degrees, it seems to pivot on its center point, and not honor the margins anymore.
For example, if I have a piece of text that for the PageLabel that is 2 inches long:
"CNTL: 1234567_ABCDEFG"
I can get this to print 17 points up and in from the lower left corner by setting margins at 17 points for left and bottom.
Then set horizontalAnchor="Left" and verticalAnchor="Bottom"
If I add the parameter rotation="90" to the instruction, then the text moves about an inch to the right, and rotates on the "7' character.
The characters after the "C" are lost off the bottom of the page.
It appears to rotate the text after placement, spinning on it's relative center.
Is there any way to place rotated text on the edges or corners without having to estimate the length and try to combine Anchor and Offset parameters?
I would like the text to be stacked up off the bottom margin, hugging the left margin.
Any help is Greatly appreciated!
Thank You
Mark